Is Rainwater Safe to Drink? What I Found in a Surrey Garden
Meta description: Is rainwater safe to drink? Find out what I found in roof-collected rainwater in Surrey, what the PFAS study really said, and what treatment and testing are needed.
There’s a water butt tucked beside a garden shed, the gutter’s dripping into it, and a bucket ready for watering the plants. It’s easy to look at that clear water and wonder: could I fill a glass from it, too?
Is rainwater safe to drink? Not straight from a roof or water butt. Rain may begin clean, but the catchment, gutters, tank and air can add bacteria, particles and chemicals. Drinking it needs a maintained treatment system and regular testing.
Is the rain itself the problem, or is it the roof?
Rain starts as water vapour, which condenses around particles in the atmosphere. As it falls, it can pick up more from the air. But in a garden harvesting system, the route from cloud to cup matters just as much.
Rain runs over roof tiles, into gutters and down a pipe before it reaches a tank. Along that route, it may collect bird or animal droppings, moss, lichen, grit and decaying leaves. A warm tank holding still water can also give bacteria a chance to multiply.
So “rainwater” can mean very different things: rain as it falls, water collected from a roof, or water that has been treated and tested. They should not be treated as interchangeable.

What did I actually find in Surrey?
While researching rainwater capture for a project in Surrey, I found significant levels of E. coli in water collected from a roof.
I’m not going to attach a number to that finding. The point is the practical one: roof-collected water can pick up faecal bacteria, even when it looks clear. Unfiltered roof-collected rainwater is suitable for irrigation, not drinking.
It’s also why I don’t think a clear glass tells you enough. You can’t see E. coli, and appearance can’t confirm what’s dissolved in the water.
What did the PFAS study everyone quotes actually say?
In 2022, researchers from Stockholm University and ETH Zurich published a study on PFAS in rainwater and other environmental media. PFAS are a large group of human-made chemicals that persist in the environment. Some travel through water and air, and can cycle back from soil and water into the atmosphere.
The researchers compared measurements with drinking-water guideline values, including some of the most conservative guidelines then in use. They highlighted how sharply some values had changed: the US guideline value for PFOA had fallen by a factor of about 37.5 million over roughly two decades.
That comparison needs context. A guideline value is not the same as a proven threshold at which harm will occur. The study’s point was that PFAS are now widespread, and that measured environmental levels can exceed some current guidelines, not that a British downpour is poison.
You can read the Stockholm University summary of the study, or the research paper in Environmental Science & Technology.
The larger takeaway is that “collect rain and it must be pure” isn’t a reliable rule. A rainwater filter may be part of a drinking-water system, but the right treatment depends on what’s in the water and how the system is used.
What is harvested rainwater genuinely fine for?
Using harvested rainwater for the garden, toilet flushing and washing is common and legal in the UK. For those uses, a basic rainwater harvesting system can be practical, provided it is set up and maintained properly.
If rainwater is used for drinking or cooking, it becomes a private water supply. Local authorities have duties to risk-assess private supplies. The Drinking Water Inspectorate’s guidance explains why source protection, suitable treatment and monitoring all matter.
Water source | What may be present | Sensible use |
Rain as it falls | Airborne particles and substances, including PFAS | Not automatically safe to drink |
Roof-collected rainwater | Roof and gutter debris, bacteria and potentially dissolved substances | Garden use; other non-drinking uses in a suitable system |
Treated and tested rainwater | Depends on the source, treatment design and maintenance | Drinking or cooking only if the complete supply is suitably treated and its quality is verified |
What does it take to make rainwater drinkable?
A drinking-water system needs more than a cartridge screwed into a pipe. Treatment should match the source water and the flow rate: water needs enough contact with the treatment media to work as intended.
A properly designed rainwater treatment train may include:
First-flush diversion to send away the dirtiest water at the start of a rainfall event.
Pre-filtration to catch leaves and larger grit before they reach the tank or finer filters.
Sediment filtration to remove suspended particles.
Carbon filtration to improve taste and reduce some dissolved organic compounds. Some carbon media can reduce some PFAS, but performance depends on the media, the specific PFAS and the conditions of use. It should not be assumed without evidence.
A final barrier and disinfection designed to control microbiological risks, including bacteria and cysts.
Testing to check whether the whole system is working for the intended use.

A rainwater tank filter is only one part of the job. I design systems around the water source, contact time and flow, rather than assuming one filter will suit every property. That is the same principle behind our scaled filtration engineering, whether a system is for a home, a borehole or a larger supply.

Why does testing come before filtration?
Because a filter can only be chosen sensibly when you know what it needs to address. And no filter makes a badly maintained rainwater system safe by itself.
Before choosing equipment, look at the whole route: roof materials, overhanging trees, gutters, first-flush arrangements, tank condition and how quickly water is used. Clean the roof, gutters and tank as part of a regular maintenance routine. Keep the tank covered and protected from animals and debris.
Then test the water using a suitable laboratory and decide what treatment is needed. The Drinking Water Inspectorate recommends that treatment be designed for the supply’s risks and flow, and that its effectiveness is checked through monitoring. That principle also applies to boreholes and springs. “Natural” doesn’t tell you whether a supply is safe; testing is the way to find out.
Frequently asked questions about rainwater
Is rainwater safe to boil?
Boiling can reduce some microbiological risks, but it does not remove dissolved chemicals such as PFAS. It also doesn’t replace a full assessment of the source and treatment system. Don’t rely on boiling alone to make roof-collected water suitable for drinking.
Can I drink rainwater if it looks clear?
No, not on appearance alone. Water can look clear and still contain bacteria or dissolved substances you cannot see. Testing is needed to understand what’s present.
Is rainwater better than tap water?
Not by default. Rainwater and tap water have different sources and risks. A properly maintained and tested rainwater supply may be suitable for drinking, but untreated roof runoff shouldn’t be treated as purer simply because it fell from the sky.
What about a simple filter jug?
A jug filter designed for mains drinking water is not a complete rainwater treatment system. It won’t reliably address the range of possible risks in roof-collected water, including bacteria. Don’t use one as a substitute for source checks, appropriate treatment and testing.
If you’re planning to use rainwater for drinking, send me your postcode and a few details about your roof, tank and intended use. I’ll help you think through what a suitable system would need. (Get in touch.)

Comments